Instruction Manual

Pre-Wiring for IP Audio and IP Video
3-3
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax [phone] / Toll Free Technical Support [phone]
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
13. Repeat steps 1 through 8 for each pre-wired room.
Pre-Wire for IP Video
Requirements
 one structured wire consisting of two twisted pair (CAT5e or better) cables and two
coaxial cables (RG6 or better)
 one four-port flush mounted wall plate consisting of two RJ45 connectors and two
F connectors
 one 16/4 DC power cable
NOTE: You can also use a NetStreams local power supply such as a PL228 or PL250 to power
NetStreams IP video products at the display location.
Procedures
Figure 3-2 shows how to pre-wire for IP-Based video.
Figure 3-2 Pre-Wiring for IP-Based Video