Instruction Manual

DigiLinX Installation and Design Guide
3-4
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax [phone] / Toll Free Technical Support [phone]
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
To pre-wire for IP-Based video, complete the following steps:
1. Install a four-port flush mounted wall plate (with CAT5e and RG6 connections) at
the video location.
NOTE: If you are installing a home theater system, also install a four-port flush mounted wall
plate (with CAT5e and RG6 connections) near the theater equipment.
2. From the head end, run the structured cable to the four-port flush mounted wall
plate.
3. From the head end, run a 16/4 cable for power.
4. Terminate using 568A terminations on the CAT5e cables.
5. Terminate F type connections on the RG6 cables.
NOTE: None of the runs should exceed 328 feet maximum cable length.