User Manual

ManualsBrandsClearOne ManualsAccessories for videoPANVP700

NS-0106-7149, Addendum 1

Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496

3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.

Addendum

PAN6400 Installation Guide

Panorama PANVP700 Video Port

The PANVP700 Video Port provides a way of connecting to a video display from a source connected to the Panorama

PAN6400 Video Distribution Center (VDC) The PANVP700 also features an IR receiver input and ships with an IR receiver.

If you have the source remote, you can control the source from any room that has a PANVP700 connected to that source. The

PANVP700 is designed for installations using the PAN6 400 as a standalone device or a PAN6400 that is controlled by a third-

party controller using RS-232.

NOTE: The PAN6400 IR receiver is disabled if the PAN6400 is connected to a Musica™ system. Musica keypads already

provide this functionality.

NOTE: Use standard, unshielded CAT5e cable for wiring between the PAN6400 and the PANVP700 and terminate it using

the 568a standard.

The PANVP700 ships with:

 a NetStreams IR receiver,

 wall plate,

 five Cable Length Compensation (CLC) cards (in 50-, 250-, 500-, 750-, and 1000-ft increments).

NOTE: The PANVP700 comes with the 250-ft CLC card already inserted into the CLC slot on the back panel.

Panels

Figure 1 shows the front and back panels of a PANVP700.

Figure 1 PANVP700 front and back panels.

Front Panel

Back Panel

Front Panel

Summary of content (4 pages)

PAGE 1
PAN6400 Installation Guide Addendum Panorama PANVP700 Video Port The PANVP700 Video Port provides a way of connecting to a video display from a source connected to the Panorama PAN6400 Video Distribution Center (VDC) The PANVP700 also features an IR receiver input and ships with an IR receiver. If you have the source remote, you can control the source from any room that has a PANVP700 connected to that source.
PAGE 2
PANVP700 Addendum Front Panel The front of the PANVP700 supports the following interfaces: IR In - Connects to a PAN6400 IR receiver. IR Out - Connects an IR emitter to the video source. Pb/Pr - Connects to component display devices. Y/Composite - Lets you connect composite or component display devices and digital audio to the PAN6400 using a yellow or green RCA connector. S-Video lets you connect S-Video to a display.
PAGE 3
Addendum PANVP700 Video Interface Module (VIM) port - uses RJ-45 connections to connect the PANVP700 with the room outputs on the PAN6400. Connecting IR Figure 3 shows how to connect IR to and from the PANVP700. To connect IR, complete the following steps: 1. Connect the 3.5 mm phono jack of the NetStreams IR receiver (included) to the IR IN port of the PANVP700. 2. Place the NetStreams IR receiver in a location where it can receive the IR signal from the source remote.
PAGE 4
PANVP700 Addendum 3. Press and hold the Menu button on the PAN6400 remote for two seconds. Lights on the PAN6400 will flash on and off. This means you’ve entered Learning mode. 4. Press the down arrow. The LED turns from green to red. The first red light under “Source” indicates you are on the first step of IR Learning. 5. Use the left and right arrow keys on the remote to select the source you want to program.