Operation Manual

283
TE – Telco Enable
This command selects/reports the hook status.
Command Form: DEVICE TE <Channel> [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels
Group Group 1 17 (R)
Value Unsigned Integer 2 0 = Off
1 = On
2 = Toggle
(Null to query in text)
TELCOLVLCTRL – Telco RX Level Control Enable / Disable
This command selects/reports the setting of Telco Rx level control.
Command Form: DEVICE TELCOLVLCTRL <Channel> [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels
Group Group 1 17 (T)
Value Unsigned Integer 2 0 = Off
1 = On
2 = Toggle
(Null to query in text)
TELOVER – Telco Current Overload
This command reports that the Telco circuitry has experienced a current overload that has forced it to go off hook.
This condition can occur because of a connection to a Digital PBX, and is done to protect the Telco Circuitry from
damage. The command is a notification only, and cannot be set or queried.
Command Form: DEVICE TELOVER <Channel><Overload>
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels
Group Group 1 17 (R)
Value Unsigned Short 2 0 = Not Overloaded
1 = OVERLOADED
TIMELOCALE – Time Locale Settings
This command sets or reports the time locale settings.
Command Form: DEVICE TIMELOCALE [DaylightSavings TimeZone TimeZoneName]
Argument Type Size Values Units
Daylight Savings Unsigned Integer 4 0 = Do not use Daylight Savings
1 = Use Daylight Savings
(NULL to Query in Text)
Time Zone Unsigned Integer 4 The number of seconds from UDT. (-86400
– 86400)
Time Zone
Argument
String 32 Description of time zone
Packet Loss Statistics
SIP Proxy Registration Status
Power Amp Fault Check
Power Amp Temp Check
Packet Loss Statistics
SIP Proxy Registration Status
Power Amp Fault Check
Power Amp Temp Check