Specifications

Signal Generator Button
The Signal Generator button opens the Signal Generator window. The
signal generator allows the PSR1212 to generate test audio signals for
sound system calibration. See page 65 for more information.
Connect to Site Button
The Connect to Site button connects G-Ware to the site directly or via
a modem. However, you must first set the appropriate parameters in the
Site Properties window before doing this.
Disconnect from Site Button
The Disconnect from Site button disconnects G-Ware from the site.
Site Roll Call Button
The Site Roll Call button sends a query over the Expansion Bus and
connects new units to the network.
Refresh Unit Screen
The Refresh Unit Screen refreshes the information on the screen,
based on the current configuration of the unit.
C, P, and M Buttons
These buttons select the Configuration, Preset, and Macro modes.
See page 34 for more information about the Configuration Mode.
See page 55 for more information about the Preset Mode.
Connect to Site Button
Disconnect From Site Button
Site Roll Call Button
TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
G-WARE SOFTWARE • TOOLBAR BUTTONS
32
C Button
P Button
Refresh Unit Screen Button
Signal Generator Button