Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
G-WARE SOFTWARE • FILTERS
38
Inputs 1-8 Filters
To configure the filters for Inputs 1-8, click Filter. The Filter Graph setup window appears. Below is a
description of each feature in the window.
Active Filter selects among filters on the graph. Note that no filters exist until you click Add Filter (see
below) to add filters to the graph.
Type selects among the following input filters: all pass, high pass, low pass, notch, and PEQ. G-Ware
features other filters, but they are configured in the Processing section of the software (see page 46).
Frequency selects the center frequency (in Hertz) for the filter you are configuring. Range is from 20Hz
to 20kHz. Default is 1000Hz.
Gain adjusts the gain value from -18 to 18dB, in .5dB steps. Default is 0dB.
Q, or Quality factor, selects the ratio of the center frequency divided by the bandwidth. Q reflects an
inverse relationship to the bandwidth, and adjusts from .02:1 to 40:1 on the PSR1212.
Bandwidth establishes the difference between the upper and lower points of a filter’s audio passband.
The Bypass box, when selected, bypasses the selected filter.
Phase generates—on the graph— the phase relationship of the graphed frequency response.
Bypass All bypasses all filters.
Add Filter adds a filter to the graph, centered at 1kHz and 0dB.
Remove Filter removes the selected node from the graph.
Inputs 1-8 Filters
Window