Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760

G-WARE SOFTWARE • COMPRESSOR CONFIGURATION

Compressor Setup Window

To enable the compressor, select the box next to Enable Compressor.

If you wish to assign this compressor to a compressor group, slide the

Group control to the appropriate group. If you don’t want to assign this

compressor to a group, select None.

When you assign a compressor to a compressor group—such as a

group of three, configured for bass, midrange, and treble—the

compressors will monitor each other. When one compressor channel

compresses and is in a group with other compressor buses, all

compressors in the group compress together. When configured

properly, this results in a smooth audio response throughout the

frequency range, with no bass, midrange, or treble dropouts. A given

compressor group must be configured for a single PSR1212 unit; a

group cannot use compressors from multiple PSR1212 units.

Next, adjust the gain of the compressor with the Gain slide control or by

using the

▲ and ▼ buttons. Note how the graph reflects the

input/output decibel levels with the gain setting you select.

The Threshold, Ratio, Attack, and Release controls are for

configuring how the compressor engages and disengages within the

processor. Following are descriptions of each control.

Compressors and compres-

sor groups can be estab-

lished only within the

PSR1212 unit being configured, i.e.,

they cannot be configured from a

single point across multiple units.

✍