Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760

ADVANCED OPERATION • PRESET CONFIGURATION PANE

Max # of Mics sets the maximum number of microphones that can be

gated On at any one time. This range can be set from one to eight

microphones or Off. To set the maximum number of microphones,

scroll through the number range (one through eight) in the pull-down

menu and select the desired number. Default is 4.

First Mic Priority helps maintain maximum audio intelligibility by only

allowing one microphone to gate on when one person is speaking.

Gentner recommends leaving this setting On. When turned Off, usually

two or more microphones gate on when only one person speaks.

However, when this parameter is turned on, one person will usually be

able to gate on only one microphone. It does this by determining the

audio level received by all microphones when the first microphone is

gated on. This audio level is then used as the ambient level for all other

mics. This mode can be enabled or disabled by clicking the box.

Last Mic Mode selects between three modes of last-mic operation:

Last On, Mic 1 and Off. Last On leaves the microphone that was

activated last full On until another microphone input is gated On. Mic 1

allows the PSR1212 to revert back to a mic 1 input when all

microphones gate off. The default setting for mic mode is Off. To select

one of the last-mic mode options, access the pull-down menu and

select the mode you wish.

To enable a particular internal or external mixer for use in a preset,

select the Use in Preset box above it.

To name each mixer, click Labels at the bottom of the window to open

the Mixer Labels window. Enter a name for each mixer, then click OK to

save changes and return to the Mixer Control window.

When you have finished making changes in the Mixer Control window,

click Close to save changes and return to the Preset Configuration

pane.

Macro Selection

The Macro Selection button opens the Preset Macros window, where

you assign specific macros to the preset you’re creating. Select the

macros you wish to use with this preset, then click OK to save changes

and return to the Preset Configuration pane. See Macro Mode on page

61 for more information about establishing macros.

Preset Macros Window