Specifications

G-Ware Macro Window
TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
ADVANCED OPERATION • MACRO MODE
62
Each macro you create can be stored and executed whenever desired.
Up to 255 macros can be configured, with an average of 150
commands per macro. If you exceed G-Ware’s capacity, you will be
notified with a warning upon saving a macro. The warning will indicate
the command line at which memory is exceeded. This warning also
displays during the macro record function if memory is exceeded while
recording a macro.
To begin creating a macro, click the M button on the G-Ware toolbar.
The Macro Record window opens.
Select the Macro to Record you wish to edit, then click Start. The G-
Ware Macro matrix window appears. Note the Macro Record window in
the center of the screen.
When you record to a saved
macro, the new recording is
appended to the end of the
saved macro.
✍
Proceed to configure the routing information on the Routing Key that
you wish to establish for this macro (see the G-Ware Configuration
Matrix section on page 34 for information about how to configure the
matrix). When you finish, click Stop in the small Macro Record window
in the upper right-hand corner of the screen. This stops the macro
recording and opens the Macro Editor window.
The macro you just created displays in the Macro Editor window. If you
wish to edit the macro, do so as described in the Macro Editor section
on page 63.