Titan Articulating Arm Dual Media Cart INSTALLATION INSTRUCTIONS Page 1
INSTRUCTIONS TITAN DUAL ARTICULATING ARM MEDIA CART CLEARONE DOCUMENT 800-300-025-01 (REVISION 2.0) February 2013. The Titan Dual Articulating Arm Media Cart is assembled from the shipped parts using standard tools.
MEDIA CART COMPONENTS USED IN ASSEMBLY Short Plate 4X Long Plate Lock Plate 2X 4X Spacer Bracket 1X Left Side Assembly 1X Right Side Assembly 1X Camera Mounting Bracket Adjustable Channel Tilt Camera Shelf TV Bracket 2 (per TV) [4] Reinforcing Plate 1 (per TV) [2] TV Mounting Tray 1 (per TV) [2] TV Inner Bracket 4 (per TV) [8] Page 3
INSTRUCTIONS FOR ASSEMBLING THE ARTICULATING ARMS AND TV’S ON THE MEDIA CART Step 1 1. Place the Right Side Assembly on the top of the cart. Note that the directional arrows at the base of the assembly are to indicate the right or left assembly and point to the outside of the cart when positioned. 2. Align the holes of the assembly to the corresponding holes on the top of the cart.
Step 2 1. Bolt the Right Side Assembly on the top of the cabinet using 4 bolts (A), 4 washers (B), 2 Short Plates and 2 Long plates with the 4 spacers (C) provided to fill the gap between the long and short plates. Be sure to put Long plates and spacers (C) outside and inside the cabinet. The Long Plates are threaded to accept the bolts. Do not overtighten the bolts. C Short Plates A Long Plate Step 3 1. Repeat the procedure for the Left Side Assembly.
Step 4 1. Assemble the Camera Mounting kit by attaching the Camera Mounting Bracket to the Spacer Bracket with 4 bolts (F) and lock nuts (G). 2. Attach the Adjustable Channel to the Camera Mounting Bracket. The Adjustable Channel has an embedded bolt that can be fastened with a nut (G) on the opposite side. 3. Attach the Tilt Camera Shelf to the Adjustable Channel using the bolt (I), spacer (J) and nut (H).
Step 6 1. Assemble the mounting for each TV display. Place the TV’s face down on a safe, non-scratch solid surface. Use the TV Brackets, Inner Brackets, Spacers, M4, M5, M6 or M8 screws, lock washers and washers suitable to the mounting holes of the TV. Position the TV Inner Brackets inside the TV Brackets, adjust to the proper spacing for your mounting holes, then place screws, washers and optional spacers so that the assemblies are firmly in place.
Step 7 1. Fully extend the arms to a position that allows for easy installation of the TVs. Lift the TV (with the attached mounting hardware from step 6) onto the Articulating Arm. Make sure the Reinforcing Plate fits snug against the Articulating Arm assembly with the weight supported by the TV Support Cleat on the articulating arm. TV Support Cleat NOTE: This operation requires the assistance of another person to lift and hold the TV into place as the attachments are made. 2.
Step 8 1. Power and equipment cables for the TV’s can be dressed through the Cable Access Holes in the Cabinet top, up through the Spacer Bracket and over to the TV Mounting Plate to conceal them and make rotation of the Articulating Arms free from obstruction. Rear View of Completed Assembly (TV’s not Shown) TV Cable Access Holes CLEARONE LOCATIONS HEADQUARTERS: Salt Lake City, UT USA 5225 Wiley Post Way Suite 500 Salt Lake City, UT 84116 EMEA Tel: 44 (0) 1189.036.053 e-mail: global@clearone.
