Installation manual

InstallatIon Manual 21
Below the local CmdTable = text are the available commands where you can enter RS-232
commands. For each command you will enter the command between the quotation marks.
For example: To enter the RS-232 command for TUNE UP:
Locate the TUNE UP command line:
[‘TUNE UP’] = “”,
Add the appropriate RS-232 command for the source to do a TUNE UP between the quotes
[‘TUNE UP’] = “W 1 6 1”,
Note that in most RS-232 Protocols you are required to put a Carriage Return to indicate an end
of command. Use %0D to indicate a Carriage Return.
[‘TUNE UP’] = “W 1 6 1%0D”,