Owner manual

Assembly
3
BEFORE YOU BEGIN
Before you begin assembling your Wood Plasma Cart, be sure to have the following:
• Chief PST-XXXX plasma mount (two for the dual configuration)
• 5/16" wrench
• Socket wrench with 5/16" socket
• Phillips screw driver
The Wood Plasma Carts require one Chief PST-XXXX plasma mount for each plasma
monitor that is to be secured to the unit.The Chief PST-XXXX comes with a static plasma
mount that connects to the cart and a plasma mounting bracket that attaches to the back
of the plasma monitor. The model of the plasma mount you will need depends on the size
and brand of plasma screen you are using. The plasma mounts are not included with the
Wood Plasma Cart systems and are sold separately. Contact the Furniture Services
Department at 1-800-283-5936 for more information.
WOOD SINGLE PLASMA CART
ASSEMBLING THE HARDWARE
1. Align the Vertical Support over the pre-drilled holes in the Universal Base.
2. Secure the Vertical Support by inserting six 5/16 1 ½” Bolts through the top of
the Vertical Support and the top of the Universal Base. Secure the bolts using six
flat washers and six 5/16 nuts underneath the top of the Universal Base.
FIGURE 2.1 Vertical Support Installation
ASSEMBLY