Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
APPENDIX E • SERIAL COMMANDS
117
Level
DESCRIPTION:
This command reports the level of an input, output, processing block or ambient level. This command is read only.
The position values are:
Alpha Numeric Level position for groups 1 (ch. 1-8) & 3 Level position for groups 1 (ch. 9-12) & 7 Level pos. for grp 2 Level position for group 5
I 1 input level input level input level level into processor
A 2 after gain adjustment, before filter input level after gain adjustment level after gain adj. amount of compression
N 3 after filter but before gate (non-gated level) N/A N/A level after compressor & filters
G 4 after gate (gated level) N/A N/A N/A
R 5 echo return loss N/A N/A N/A
E 6 echo return loss enhancement N/A N/A N/A
T 7 ERL + ERLE N/A N/A N/A
D 8 impulse duration (tail time) N/A N/A N/A
C9AGC AGC N/A N/A
RETURN VALUES:
Unit always returns the last executed LVL selection in the same form as above.
TEXT FORM DETAILS
COMMAND FORM: <DEVICE> LVL <Channel> <Group> [Position Value]
Where:
<DEVICE>: See General Text command form Description
LVL Text Command
Channel See Groups and Channels (Table 1, page 95)
Group ‘I’, ‘O’, ‘M’, ‘P’, ‘A’, ‘L’
Position Position in audio channel. See position table above.
Value Returned level value measured in dB
RETURN VALUES
The command will return the updated level of the selection in the same format as the command was issued. All
return gain values are absolute and reflect the actual internal gain.
If Command Returns
The level of Input 9 is desired DEVICE LVL 9 I I –10
The level of the non-gated Input 3 is desired DEVICE LVL 3 I N –6