Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
APPENDIX E • SERIAL COMMANDS
121
Master
DESCRIPTION:
This command reports the mode of the unit. The mode can be Master or Slave.
RETURN VALUES:
Unit always returns the master command in the same form as above.
TEXT FORM DETAILS
COMMAND FORM: <DEVICE> MASTER <Value>
Where:
DEVICE: See General Text command form Description
MASTER Text Command
Value
1 select master unit
2 select slave unit
Null return the current mode of the unit
RETURN VALUES
The command will return the mode of the unit in the same format as the command.
If Command Returns
Selection is for a single unit DEVICE MASTER 1
Matrix
DESCRIPTION:
This command selects/reports the matrix routing of an input to an output. The values allowed are:
Alpha Numeric Description
0 0 Cross point disabled
1 1 Cross point enabled
2 2 Cross point toggle
N 3 Non-Gated (Mic ch. 1 –8 only)
G 4 Gated (Mic ch. 1 – 8 only)
RETURN VALUES:
Unit always returns the last executed MTRX selection in the same form as above.
TEXT FORM DETAILS
COMMAND FORM:
<DEVICE> MTRX < SrcChannel > < SrcGroup > < Dest Channel > <Dest Group> [Value]
Where:
DEVICE: See General Text command form Description
MTRX Text Command
Src Channel See Groups and Channels (Table 1, page 95)
Src Group ‘I’, ‘M’, ‘P’, ‘L’, ‘E’ See Groups and Channels (Table 1, page 95)
Dest Channel See Groups and Channels (Table 1, page 95)
Dest Group ‘O’, ‘P’, ‘E’ See Groups and Channels (Table 1, page 95)
Value See table at beginning of command. A value of null returns the current mode.