Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
INSTALLATION AND SETUP • LCD MENU TREE
11
The three main menus are: System, RS-232, and Meter. All submenu
items are arranged under these menus. Use the ENTER button to
descend into a menu and its submenus and ESC to ascend back out.
Use the
▲ and ▼ buttons to select between items within a specific
menu or submenu group. When the last menu item is reached, the
display scrolls back to the beginning of the list, and vice-versa. Holding
down an
▲/▼ button increases the scrolling repeat rate.
To adjust a parameter, first verify that the LCD shows the parameter
flashing. If the parameter is not flashing, it cannot be adjusted until
ENTER is pressed. If the parameter is flashing, adjust the value with the
▲ and ▼ buttons. As the value is adjusted, the parameter is updated
immediately. To store the new value, press ENTER. To discard the
change and revert back to the old value, press ESC. If the METER
button is pressed while a parameter is being adjusted, the LCD will
switch to the Meter menu.
Parameters that toggle between two values (or are a list of values) will
wrap around. Holding down an
▲/▼ button longer than two seconds
will engage a faster repeat rate through menu items.
Security
There are two aspects to XAP 800 security (see the System-Level LCD
Parameters figure at right): locking the front panel and the passcode.
Lock P
anel
Locking. The front panel may be locked to prevent unauthorized
adjustments to the XAP 800. To lock the front panel, use the
▲/▼
buttons to select the System menu, then press ENTER. Then scroll
through the menu items to select LOCK PANEL and press ENTER.
Select ON and press ENTER again.
Unlocking. To unlock the front panel, attempt to adjust a parameter. The
XAP 800 will prompt for the passcode. Upon entering the fifth character
(if entered correctly), the front panel will unlock. The default passcode
for all boxes is
▲▲▼▼ENTER.
Set passcode
Once the XAP 800 is unlocked, the passcode may be changed. Before
the XAP 800 will allow passcode changes, the new passcode must be
entered, then re-entered to validate the new passcode.
The front panel passcode can also be set (and reset) within G-Ware.
See page 24 for more information.
Power-Up Screen
Gentner XAP 800
Version X.X
System
Select Preset
Lock Panel
Set passcode
Device ID
Mixer Mode
Unit ID
Firmware Version
System-Level LCD Parameters
Menu items can still be
scrolled through when the
panel is locked. However,
settings cannot be entered until the
panel is unlocked with the appropri-
ate passcode.
✍