Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760

INSTALLATION AND SETUP • SECURITY

System Menu

There are seven system-level parameters (see System-Level LCD

Parameters figure on previous page): Select Preset, Lock Panel, Set

passcode, Device ID, Mixer Mode, Unit ID, and Firmware Version. The

latter two are read only; they cannot be changed.

Select Preset

The SELECT PRESET menu item allows for one of 32 preprogrammed

presets to be selected for XAP 800 use. These preset configurations

can be easily loaded via serial commands to the RS-232 port. For

example, the XAP 800 may be set up for different room microphone

configurations (i.e. Preset 1 for a two-mic presentation, Preset 2 for an

eight-mic conference, Preset 3 for a three-mic priority panel discussion

with 20 mics for audience questions, etc.). To select a preset, scroll

through the numbered presets (1-32) until the desired preset is visible,

then press ENTER. The preset will immediately be loaded into the

XAP 800 memory for active use.

Device ID

The XAP 800’s device ID is set from this menu. There are eight device

ID selections to choose from (0–7). Select the network position you

wish to use. Within a single site, you must designate different device ID

numbers for each XAP 800 unit. See Step 3—Device ID, page 9.

nit ID

The UNIT ID menu selection allows you to access the read-only address

set at the factory. This unique ID number identifies your particular

XAP 800 unit and cannot be changed.

Firmware V

ersion

This menu selection allows you to view which firmware version is being

used. This information cannot be changed.