Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
G-WARE SOFTWARE • ADDING A XAP 800 UNIT TO A SITE
23
The next step is to add a XAP 800 unit to the site setup you’ve created.
1. In the G-Ware Main Screen, click the Add Unit to Current Site
toolbar button. This opens the Add Unit window.
Adding a XAP 800
Unit to a Site
Add Unit to Current Site Button
For most applications, you
should set the Unit Type to
Slave. The Master setting is
used if you wish to split large sys-
tems into smaller groups with inde-
pendent Expansion Bus audio rout-
ing. Global control of the system is
still maintained through the first
XAP 800 unit in the system.
✍
Unit Properties — New Unit/General Tab Window
2. In the Add Unit window, click the XAP 800 icon, then click Add.
This opens the Unit Properties—New Unit/General Tab window.
3. Enter the Unit Name you wish to use for the unit (it will show up
on the front panel LCD). Next, select the Device ID (default is 0). If
you’re using two or more networked units, enter the appropriate
number the XAP 800 unit will be in the sequence.
4. Select the Unit Type (default is slave) and Default Meter
(default is Output 12) settings you wish to use. Select Slave unless
you wish to split the system into smaller groups, in which case you
would select Master. When Master is used, any audio data received
from units ahead of it in the link will be ignored. This allows large
systems to be split into smaller groups with independent Expansion
Bus audio routing. The order in which the Expansion Bus
connections are made determines which units can be masters to a
slave or group of slave units.
5. Select the Meter Refresh Rate, which determines how quickly
the XAP 800 updates meter information (default is 100ms; range is
50-1000ms).
Add Unit Window