Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760

G-WARE SOFTWARE • PULL-DOWN MENUS

Tools Menu

Gating opens the Gate View window, which can also be opened with the

Gate View toolbar button. See Gate View on page 65 for information.

Meters opens the Meter Views window. This window can also be opened

with the Meter View toolbar button. See Meter Views on page 66 for more

information.

Signal Generator opens the Signal Generator window. This window can

also be opened with the Signal Generator toolbar button. See Signal

Generator on page 66 for more information.

Execute Preset opens the Execute Preset window, where you select the

saved preset you wish to run, then click Execute.

Run Macro opens the Run Macro window. Here, you select which macro

you wish to run. Then click Run to initiate the macro.

Compare Utility opens the Document Compare Utility window. This

window allows you to compare information between two XAP 800 sites,

two units, or a site and a unit. See page 68 for more information.

Message Log opens the Message Log window, which displays

messages indicating successful or unsuccessful site connection and all

errors. The Message Log displays error information automatically.

Help Menu

Contents F1 opens the G-Ware Help File, where you can search for

information via a table of contents, index, or search.

About opens a window displaying G-Ware version information.

Tools Menu

Help Menu

Connect Menu

Connect connects G-Ware to the site directly or via a modem. However,

you must first set the appropriate parameters in the Site Properties

window before doing this. See page 21 for more information.

Disconnect disconnects G-Ware from the site.

Site Roll Call sends a query over the Expansion Bus and connects new

units to the network.

Refresh Unit Screen refreshes the information on the screen, based on

the current configuration of the unit.

Connect Menu

Unit Properties opens the Unit Properties—Unit 1 (or the name you have

given to the unit) window. This is where you adjust parameters for a unit

that has already been configured. See page 23 for more information.