Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
G-WARE SOFTWARE • TOOLBAR BUTTONS
30
GPIO Builder Button
Add Unit to Current Site Button
The Add Unit to a Site button opens the Add Units window, where you
select the Gentner unit you wish to add to the site. Adding a unit to a
site is covered in detail on page 23.
Gating Control Button
The Gating Control button opens the Gating Control window. This is
where you set parameters for internal and global XAP 800 mixers. The
Gating Controls window can also be accessed by clicking the Gating
Control button on the Preset Configuration pane. This section is
covered on page 44.
Macro Editor Button
The Macro Editor allows you to add new commands and remove
commands from existing macros. This function is described on page
64.
GPIO Builder Button
The GPIO (general purpose input/output) Builder button opens the
GPIO window, where you can assign commands for the control/status
pins. This gives you real-time flexibility to meet a variety of conferencing
requirements. See page 60 for more information.
Control Panel Builder Button
The Control Panel Builder button opens the Control Panel Builder
window, where you can program the operation of the Control Panel. See
page 61 for more information.
Add Unit to Current Site Button
Gating Control Button
Macro Editor Button
Control Panel Builder Button