Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
G-WARE SOFTWARE • CROSS POINT ATTENUATION
35
Cross Point Attenuation
Right-click on a box within the matrix to open the Cross Point menu.
Click Cross Point Enter to open the Cross Point Attenuation Dial
window.
Cross Point Menu
Cross Point Attenuation
Dial Window
Click the ▲ and ▼ buttons or click on the green indicator and rotate
the dial with the mouse to adjust the attenuation to the level you desire
(or enter the numerical value directly in the window). The attenuation
range is from 0 to -60dB. Click Close to exit.
Note that the level control you have selected for the cross point is
indicated numerically in the matrix.
By right-clicking the mouse, the Cross Point menu also allows you to
copy and paste the current Cross Point configuration, including the
attenuation adjust setting, to other cross points. To copy and paste a
cross point to multiple cross points, press CTL-C to copy (or right-mouse
click). Then, holding down CTL-V, drag the mouse over the cross points
you wish to copy the settings to. You can also copy and paste an input
or output to any other input or output or to all inputs and outputs.
Note the yellow gated, blue non-gated, and green cross point boxes in
the Routing Key box (matrix area). Repeated clicking on any box in the
matrix (except the black boxes) alternately highlights the box as
selected for the following configurations: yellow (gated; Inputs 1-8 only),
blue (non-gated; Inputs 1-8 only), and green (cross point), depending
on what can be configured in a particular area of the matrix.
Referencing the input, output, Expansion Bus, and processing bus
intersections on the X and Y axes of the matrix, proceed to configure
the gating, non-gating, and cross point routing parameters.
As you move the cursor
over the Input, Expansion
Bus, Processor, and Output
labels, note that the cursor
becomes a hand. Click on any of
these buttons to open a function or
labels window where you can
assign names for each parameter.
✍