Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760

ADVANCED OPERATION • GATE VIEW

Delete removes the selected macro.

Replace replaces the selected macro with the one you’re editing.

You can also move commands simply by clicking on them and dragging them to the

location you desire.

Note that the drop-down menus below the Insert and Replace buttons change to

reflect editable variables for each command you select. For many commands, the far-

right menu allows you to set the command state to 0, 1, or 2. 0 does not execute the

command; it will simply clear the command’s flag, if it is set. One executes the

command and sets the flag to on. Two executes the command and resets the flag.

Run Macro runs the selected macro so you can check for problems. The macro must

be saved before you can run it (see Save As and Save below).

Clear Macro erases the macro from the window.

Save As opens the Save Macro window. Here, you select which macro number you

wish to use. Then click Save, which saves the macro and returns G-Ware to the G-Ware

matrix window.

Save saves the macro changes you have made.

Close returns G-Ware to the G-Ware matrix window.

Gate View

The Gating button opens the Gate View window, which allows you to view gating

activity at each mic input.

Gate View Window

Select the Enabled box for each XAP 800 unit you wish to observe

input gating information for. Note that the window shows gating activity

only for units which have been added to G-Ware. The gate indicator for

each input is dark green in the gate-off condition and light green if the

input is gated on. Click Close to save the settings and exit.

Gating Button

An asterisk

(*) appears

before the

name of a saved

macro.

✍