Specifications

TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
APPLICATION EXAMPLE • MULTI-ROOM CONFERENCING
74
Speaker A
Room A
Room B
Room C
Speaker B
Speaker C
Mic 2
Mic 4
Mic 6
Mic 1
Mic 3
Mic 5
Removable
room partition
Removable
room partition
Control Panel
Control Panel
Control Panel
Transmit
ansmit
Rec
ec
eiv
eiv
e
On
On
Off
ff
HAP T 2
XAP TH2 Telephone Interface
Multi-Conference Room
The Multi-Conference Room diagram above shows three rooms with removable
partitions separating the rooms. The XAP 800 can be pre-set to route microphone
audio to one room or any combination of rooms.
For example, say all three rooms are closed off for separate meetings. You can
configure a preset to route the microphone audio only to the speaker in the same
room, with microphone gating properties applied as desired. Then, say the divider
between Rooms A and B is removed for a combined meeting. You can use a preset
that gates off microphones 3 and 4, while the audio from microphones 1 and 2 are
routed to all speakers in Rooms A and B—while retaining the settings for the
ongoing meeting in Room C. Later, when all partitions are removed for a final group
meeting, you can use a preset that gates on only microphones 1 and 2, but routes
audio to all speakers.
The use of other audio sources can be configured using the XAP 800’s parametric
equalizers and filters to enhance audio quality. For example, a XAP TH2 Telephone
Interface could be used in each room for audio or video conferencing capabilities
(note the XAP TH2 in the diagram above).
After you have installed the XAP 800 unit and software, and made the necessary
connections, follow the steps below to set up the XAP 800 for this application.
Step 1. Establish a XAP 800 Site
In G-Ware software, establish a new XAP 800 site and then add the XAP 800 to the
site, as described on pages 21-24.