Installation

ManualsBrandsClearsonic ManualsAcoustic TreatmentA2466x6 Drum Shield

1. Open all boxes and check for damage. Call us immediately if you have any damaged or

missing items. Save your boxes and packing for as long as possible or at least a few weeks.

2. Stand up the main 5.5’ tall base panel shield systems in zigzag formation with the base

channel on bottom.

3. Peel masking off panels. (Once masking is

removed panels can not be returned. Test your

MegaPac with masking first if you are not sure.)

Using gloves to handle acrylic panels will help

keep them free of finger prints during assembly.

4. Install H-channels on top of 5.5’ tall

shields. Outside edge of H-channel should

line up with outside edge of shield below.

Lubricate the top of the panels with rubbing

or other quick-drying alcohol solution to aid

installation.

5. Note the number of panels and hinge configuration of each shield system. Be sure the

number of panels matches, and that everything will fold correctly once installed. Have your

assistant “feed” the folded AX panels one at a time while you place them into position atop the

larger shields. Make sure the edges line up. Don’t seat the AX panels completely until all are in

place. Tap the top of the AX panels with rubber mallet to seat completely into H-channel on

both panel systems.

ClearSonic MegaPac and MiniMega Instructions

Summary of content (4 pages)

PAGE 1
ClearSonic MegaPac and MiniMega Instructions 1. Open all boxes and check for damage. Call us immediately if you have any damaged or missing items. Save your boxes and packing for as long as possible or at least a few weeks. 2. Stand up the main 5.5’ tall base panel shield systems in zigzag formation with the base channel on bottom. 3. Peel masking off panels. (Once masking is removed panels can not be returned. Test your MegaPac with masking first if you are not sure.
PAGE 2
6. Fold up the larger of the two panel systems and “walk” it to the front center of the drum kit or whatever you’re isolating. 7. With one person on each side, unfold the system and wrap it around the kit. 8. Use your fingers to lift the panels at the bottom cable cut-outs to pull or push system into final position. End panels should be parallel and symmetrical on either side of the kit, about 7 feet apart for most applications. 9.
PAGE 3
11. The extra ‘H’ channel provided with your MegaPac will help keep the lid from obstructing the door panel when entering and exiting. Place this on top of the AX panel next to your door. 12. Adjust both Lid support bars to the width of the font panels. Rest one support bar on top with the J-hooks at least 4-inches from the edge of the end panels. Place the other bar about a foot in front of the first. Do not extend the bar beyond the red limit mark. 13.
PAGE 4
ClearSonic MegaPac ClearSonic Mini-MegaPac Thank you for using ClearSonic products. Please contact us should you have any questions or concerns about MegaPac assembly or operation. 800-888-6360 * info@clearsonic.