Installation

11. The extra ‘H’ channel provided with your
MegaPac will help keep the lid from ob-
structing the door panel when entering and
exiting. Place this on top of the AX panel
next to your door.
12. Adjust both Lid support bars to the width of the
font panels. Rest one support bar on top with the
J-hooks at least 4-inches from the edge of the
end panels. Place the other bar about a foot in
front of the first. Do not extend the bar beyond the
red limit mark.
13. Lay the rectangular 2’ wide STC5 on top (about six inches from the center of the front
panels) with at least a one inch over-hang in front. The Lid sections will be resting on the
support bars in back. Place the 1’ wide STC512 right next to it with same over-hang. Com-
plete the lid with the STS trapezoid sections. You may have to make adjustments to the
panels and/or lid in order to achieve maximum coverage.
14. If not pre-attached, place Velcro on all four corners of the S2 and S1 baffles about 1-inch
from the edge. Peel off the paper to expose the adhesive
15. Place the S2 and S1 baffles in position on the shields. When attaching SORBER baffles to
your door panel, raise the bottom S2 approximately ½ inch off the ground so it does not drag.
It works best to have an assistant apply pressure from the opposite side while pressing on the
baffle corners to make sure the Velcro sticks securely. (See SORBER diagram on following
page for configuration)
16. Clip fan to the back of the STC or on one of the support bars to aid in air exchange.
17. Enjoy Your MegaPac!