User's Manual
Customer Information
1. This equipment complies with Part 68 of
the FC C rules and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among other in formation, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
2. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord
and modular plug is provided with this product. It is designed to be connected to a compatible modular jack
that is also compliant. See installation instructions for details.
3. If this equipment [US:CLSW401BA700] causes harm to the telephone network, the telephone company will
notify you in advance that temporary discontinuance of service may be required. But if advance notice isn't
practical, the telephone company will no tify the customer as soon as possible. Also, you will b e advised of
your right to file a complaint with the FCC if you believe it is necessary.
4. The telephone company may make ch anges in its facilitie s, equipment, oper ations or procedures that could
affect the operation of th e equipment. If this happens the telephone company will provide advance notice in
order for you to make necessary modifications to maintain uninterrupted service.
5. If trouble is experienced with this equipment [US:CLSW401BA700], for repair or warranty information,
Service can be facilitated through our office at:
U.S. Agent Company name:ClearsoundsCommunications,Inc.
Address:1743QuincyAvenue, Naperville,IL60540,USA
Tel:630.654.9200
Fax:630.654.9219
If the equipment is causing harm to the telephone network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
6. Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do not alternate or
repair any parts of device ex cept specified. For r epair procedures, follow the instructions outlined under th e
limited warranty.
7. Connection to p arty line service is s ubject to state tariffs. Contact the state public utility commission, public
service commission or corporation commission for information.
8.
If your home h as specially wired alar m equipment connected to the telephon e line, ensure the installation of
this [W4] does not disab le your alarm equ ipment. If you h ave questions abo ut what will d isable alarm
equipment, consult your telephone company or a qualified installer.
9. If the telephone company requests information on what equipment is connected to their lines, inform them of:
a) The ringer equivalence number [0.1B]
b) The USOC jack required [RJ11C]
c) Facility Interface Codes (“FIC”) [02LS2]
d) Service Order Codes (“SOC”) [9.0Y]
e) The FCC Registration Number [US:CLSW401BA700]
10. The REN is used to determine the number of devices that may be connected to a telephone line. Excessive
RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but
not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may
be connected to a line, as determined by the total RENs, contact the local telephone company. The REN for
this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented
by ## are the REN without a decimal point. For this product the FCC Registration number is
[US:CLSW401BA700] indicates the REN would be 0.1B.
Compliance
129
HearingAidCompatibility(HAC/VC)
The DECT Handset meet the FCC stan
dard for
HearingAidCompatibility.
Suite 143