User's Manual

6
Low Battery
Under normal usage condition, the fully charged battery can
operate up to 3-hour of talk time and up to 120-hour of
standby time. During on state, when the battery power is
running low, the Neckloop beeps once every 30 seconds
and the red indicator flashes every 30 seconds. Charge the
Neckloop as described above; else the Neckloop will shut
down when voltage fall below operating voltage.
u Turning On and Off the Neckloop
u Set up wih the Phone for the first time
To turn on:
To turn off:
press and hold the MFB for 3 seconds; the
Neckloop beeps once and Blue indicator flashes 4 times.
The flashing continues once every 3 seconds after the
Neckloop goes to standby mode.
press and hold the MFB for 3 seconds; the
Neckloop beeps once and the Red indicator flashes 4 times,
and power off.
Before using your Neckloop for the first time, you must pair it
with your Bluetooth phone. The following information
describes a typical pairing procedure between a Neckloop
and a Bluetooth phone. However, the pairing procedure
may subject to different makes and models of the phones.
13
Ensure both the Neckloop and phone is within 10 meters
operating range. There are no obstructions or inter-
ference in between.
Ensure the phone has the latest and working firmware.
Send phone for firmware update.
Power off and on the devices if the above steps do not
solve the problem.
If problem persists after taken all above steps, send the
Neckloop to authorized service center. Check with the local
dealer.