Installation guide

Addendum

A50 HANDSET REGISTRATION

1 Begin with handsets fully charged for 24 hours. Remove

all handsets from the charging bases, bringing all of them to the

main base and setting them on the counter right next to the

main charging base. (The handsets cannot be registered while

they are in the charging base). Get ready for this 2-handed

process.

2 Put your one finger on the PAGE button on the main

base. Very important - - You must hold this button down

during the whole registration process for all involved handsets

without lifting it off. If the button is released, you must start

over.

3 At the same time - - with your other hand, press and hold

the "CH" button on the 1st handset until you hear 2 quick

confirmation beeps.

4 Immediately move your hand to the next handset – without

lifting the PAGE button, press and hold

the "CH" button on the

2nd handset until you hear 2 quick confirmation beeps.

(Repeat for 3

handset if applicable – without lifting the PAGE

button).

5 Release your hand from the PAGE button now on the main

charging base.

6 Handset 1 should now show "HS-1" on the display.

Handset 2 should now show "HS-2" on the display. (If you have

a 3

Handset, it will now show “HS-3”).

7 You should now have a dial tone on all the handsets.

NOTE:

If any handset loses registration, then this process must be

repeated for all handsets in order to bring all handsets back into

registration.