User Manual

4
3 Installation
Important
 Before the installation, please make sure the installation surface can sustain at
least 3X weight of the bracket and the camera.
The dome camera usually uses the ceiling installation. It can be installed on the ceiling or the
wall. Please refer to Figure 3-1 for installation hole site.
 For side exit cable installation, please make sure the side exit cable direction is the same
as shown in the installation position map.
 Before you secure the screws on the pedestal, please put the cable through the cable exit
of the pedestal.
 Before you complete the installation and debug, do not remove the electrostatic film. After
you remove the film, do not touch the enclosure in case there is any scratch.
Figure 3-1