User Manual

6
3 Installation
Important
 Please install the device in time after it is taken apart, which is to avoid the camera
module being exposed to damp environment for too long.
 Before the installation, please make sure the installation surface should be thick
enough to sustain at least 3X weight of the camera.
Figure 3-1
Step 1
Before you install the camera bracket, pull the cable through cable exit of the bracket chassis.
• It needs to install expansion bolt first if it is the cement wall (Please make sure the
installation holes of expansion bolt are the same as those of the bracket), then use
self-tapping screws to install bracket, see Figure 3-1.
• You can skip the first step if it is the wooden surface, use self-tapping screws to
install bracket directly.
Step 2
Adjust camera monitoring direction.
Loosen the screws on the bracket as is shown in Figure 3-2, adjust the camera to exact
location which needs to be monitored via rotating bracket and camera body, then fix the
screws firmly.
Figure 3-2