User Manual

7
3 Installation
Dome camera mainly uses ceiling installation; installation surface includes ceiling and wall.
Users can install the device with the installation position map and the screws in the
accessories bag.
Attention:
 Please install the device in time after it is taken apart, which is to avoid the camera
module being exposed to damp environment for too long.
 Before the installation, please make sure the installation surface is thick enough to
sustain at least 3X weight of the camera.
 For the installation mode of side outlet, make sure the direction of side outlet is in
accordance with that of the installation position map when sticking the installation
position map. Besides, pull the cable through the pedestal cable slot before locking
the screw.
Please refer to the following installation steps if it is model A, B or C.
Figure 3-1
Step 1
Dismantle the pedestal. There are two ways to dismantle the pedestal according to different
models.
 Model A: Hold the decoration ring tightly, rotate the pedestal counterclockwise, release the
buckle and take off the pedestal.