Specifications

Electric Tool Control TME-100 Series
en03d141.fm, 30.01.2001 PL12-1300 12/00 39
Cleco
3.6.2 Communications / Serial Data Transmission
Fig. 3-17: Data Transmission
The Serial Data Transmission is sent after each cycle to the programmed COM port. The Basic
settings are Port, Baud rate, Data bits, Stop bits, Parity, and Protocol. The following table details
the transmission data:
Start End Length or Value Description
1142 hex B
2 3 2 Digit ASCII Tool Number
4 5 2 Digit ASCII Parameter Set
6 17 12 Char ASCII Date and Time (YYMMDDHHMMSS)
18 24 7 Digit ASCII Peak Torque
25 31 7 Digit ASCII Low Torque Limit
32 38 7 Digit ASCII High Torque Limit
39 39 1 Char ASCII Status Torque Status Flag
L = low
A = accept
H = high
40 46 7 Digit ASCII Final Angle
47 53 7 Digit ASCII Low Angle Limit
54 60 7 Digit ASCII High Angle Limit
61 61 1 Char ASCII Status Angle Status Flag
L = low
A = accept
H = high
c00292en.bmp