Specifications

Cleco
Electric Tool Control TME-100 Series
66 PL12-1300 12/00 en05d141.fm, 30.01.2001
control parameters the parameters that define the fastening strategy
sequence for a given tool
cycle complete active whenever tool is not running
cycle NOK active if torque/angle/yield are outside limits or some
other error has occurred
cycle OK active if torque/angle/yield are within programmed limits
cycle start switch the switch on a tool that initiates a run cycle
default parameters parameters automatically selected by the unit
desired final torque the final torque desired in a fastening process (referred to
as torque setpoint)
end delay time [ms] time delay from the tool turnoff until the torque measure-
ment ends
engineering units units of torque measurement
external transducer a transducer physically located on the outside of a tool
fastener rotation direction in which a fastener rotates
fastening strategy a strategy used to control or monitor a fastening process
final angle the final angle desired in a fastening process
histogram a printout generated from statistical data output
if NOK go to stage gives the control system direction if the stage is NOK
internal transducer a transducer physically located inside the tool
LCD screen the screen on the unit that provides directions to program-
ming the unit
LED flashing in reverse if yes, the tool LED's will blink when the tool is in reverse
LED screen the screen on the unit that provides the readout data from
a run cycle
load refers to the amount of torque applied to a device or tool
main menu the first menu that appears on LCD screen
marking output output from paint marker solenoid after each cycle
master transducer a transducer used as a benchmark to calibrate another
transducer
max. fastening time [mS] max time for the tool to run during the stage
mean (Xbar) the average of all readings taken in a sample
NOK after reverse if yes, the controller will report an NOK if the tool is run in
reverse
peak torque the maximum torque achieved in a run cycle