Specifications

Electric Tool Control TME-100 Series
en05d141.fm, 30.01.2001 PL12-1300 12/00 67
Cleco
port the socket used for connecting a cable or peripheral
equipment
power supply a unit used to supply power to an electrical device
pulses per degree number of encoder pulses generated by the tool when
rotating the head exactly 1 degree or 1/360 of a revolution
range (R) a statistical measurement of the difference between the
lowest and highest reading taken in a sample
redundant transducer secondary transducer used to read torque
redundant transducer calibra-
tion
the calibration process of the secondary transducer
reject interlock the stopping of further operation of the system after a pre-
determined number of rejected cycles has occurred
rejected data the data generated by unacceptable rundowns
rejected rundown a rundown that has not met the criteria of a fastening
strategy
remote parameter select a remote device that bypasses the parameter select but-
ton on your unit
rundown printout gives the control system direction for when to print
run number number of accepted and rejected rundowns
second transducer frequently referred to as the redundant transducer
sequence 11 high speed rundown
sequence 30 torque control/angle monitor
sequence 50 angle control/torque monitor
sequence 41 angle controlled backoff
speed max speed of the nutrunner during the tightening stage
standard deviation (
σ) the measurement of the scatter of the population around
a mean
start delay time [ms] time delay before the stage will start
start spike time [ms] time delay for the control system to start measuring
torque after the stage starts
statistical data data used to measure the performance and accuracy of
the unit and tool
status light lights located either on the unit or tool that represent
accepted and rejected cycles
sub group size (Sub Sz) the sub group size of data used for statistical analysis; the
smallest sub group size = 5