Specifications

Cleco
Electric Tool Control TME-100 Series
8 PL12-1300 12/00 en01d141.fm, 30.01.2001
After the Navigator Menu is displayed, verify the Tool Memory by entering Tool Setup. If Tool
Memory is not active then select a tool using the Tool Library. Press the ship's wheel to return to
the Navigator Menu.
Once Tool Setup is complete the application needs to be programmed. To do this, go to Basic
Application Builder. From this screen torque, angle, and speed parameters must be entered for
the selected application. Press the ship's wheel to return to the Navigator Menu.
The controller is now ready to begin fastening cycles. The torque and angle data can be viewed
by pressing the Run Key. Tool and controller indicator lights will illuminate according to the
results.