Owner's Manual
Re
cycling
-
Your product is designed and manufactured with high quality materials and components,
which can
be
recycled and reused. When you see the crossed
out
wheel bin symbol attached
to
a product,
it
means the product is covered
by
the European Directive
2002
/
96
EC
:
Never dispose
of
your
product with
other
household waste. Please inform yourself about
the
local rules on the separate collection
of
electrical and electronic products. The correct
disposal
of
your old product helps prevent potentially negative consequences on the
environment and human health. Your product contains batteries covered
by
the
European
Directive
2006
/
66
/
EC,
which cannot
be
disposed
of
with normal household waste.
The device complies with
RF
specifications when the device used at 0mm from your
body
. This device may
be
operated in all member states
of
the
EU
. Declaration for
EU
compliance: Operation Frequency Band/Max.
RF
power
transmitted: 2402-2480MHz. <10dBm. Hereby. Cleer Limited declares that the radio equipment
type 'headphone' is in compliance with Directive 2014/
53
/
EU
This device may
be
operated in all
member
states
of
the
EU
.
Declaration
for
EU
compliance: Operation Frequency Band/Max.
RF
power
transmitted:
2402
-2480MHz, < 2.5mW.
Compliance with FCC rules
NOTE: This equipment has been tested and found
to
comply with
the
limits for a Class B digital device.
pursuant to part
15
of
the FCC Rules. These limits are designed to provide reasonable protection against
harmful Interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and,
if
not
installed and used in accordance with
the
instructions, may cause harmful
interference
to
radio communications. However, there is no guarantee that interference will
not
occur in a
particular Installation.
If
this equipment
does
cause harmful interference
to
radio
or
television reception.
which can
be
determined
by
turning the equipment
off
and on, the user is encouraged
to
try
to
correct the
interference by
one
or
more
of
the
following measures:
- Reorient
or
relocate
the
receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect
the
equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult
the
dealer
or
an experienced radio/TV technician
for
help
Changes
or
modifications
not
expressly approved by the party responsible for compliance could void the
user's authority
to
operate the
equipment
This device complies with Part
15
of
the FCC Rules. Operation is subject
to
the following
two
conditions:
(1) this device may
not
cause harmful interference, and
(2)
this device must accept any interference received,
including interference that may cause undesired operation.
13