Manualshelf

User's Manual

ManualsBrandsCleveland Medical Devices ManualsElectronicsLow noise 2-ch wireless data acquistion system
11121314151617181920
Cleveland Medical Devices Inc. RatPaak™ User’s Guide
Testing the Equipment with the Test Pack
1. Plug the Receiver into an available RS-232 computer port using the serial port cable and connect the
AC Adapter power cord (or 9V battery) to the serial port cable.
2. Check to see that the COM port is displayed on the Status Bar. It should correspond with the COM port
chosen in the Device tab of the Options screen.
3. Connect the Transmitter to the Test Pack.
4. Turn the Transmitter “ON” by flipping the ON/OFF switch. The Transmitter serves as the power
source to the Test Pack.
5. Click the Preview Data button on the Main Toolbar.
A 10 Hz, 300µV peak-to-peak square wave should scroll across the screen. If you do not receive a visible
signal, refer to Capturing Data or Chapter 6, Troubleshooting.
19
CleveMed Proprietary
Information