User guide

INSTRUCTION NUMBER: AO-70165 3of 9

M (BOLT DIA)

X (BOLT DIA)

SLIM CELL (ALONE) MOUNTING BRACKET (WITH SLIM CELL)

1.4 DESCRIPTION

The Cleveland-Kidder SLIM CELL transducers utilize

a sensing twin beam to which semiconductor strain

gages are bonded. With these high output signal gages

a very small force on the sensing beam will be shown

as a change in the tension signal.

For many applications SLIM CELL transducers are for use

with rotating (live) shaft rolls that are traditionally mounted

in Pillow Block Bearings. See Figure 1. For mounting

dimensions see Figure 2. But SLIM CELL transducers can

also be used with stationary (dead) shaft rollers.

Dimensions in inches, allow 2.5 in clearance for Connector

SIZE A B C D E* F G H I J K L M

SLIM1 4.50 3.75 2.996-3.000 1.50 - 0.12 1.31 1.02 0.07 2.30 2.00 0.65 _ (3)

SLIM2 5.80 4.75 4.196-4.200 2.46 - 0.14 1.70 1.32 0.10 3.05 2.50 0.65 3/8 (3)

N O P Q R S T U V W X Y**

1.02 4.22 4.78 6.00 3.000-3.006 4.50 0.55 0.55 1.60 4.75 3/8 (2) _ (3)

1.36 5.50 6.5 8.00 4.200-4.206 5.80 0.65 0.65 2.00 6.2 _ (2) 3/8 (3)

* See Table 3 for permissible Shaft Diameter. Bore Diameter is typically between Nominal Diameter+0.0007 and +0.0017 inch.

** Bolts supplied with bracket

Dimensions in mm, allow 64 mm in clearance for Connector

SIZE A B C D E* F G H I J K L M

SLIM1 114.3 95.3 76.10-76.20 38.1 - 3.0 33.3 25.9 1.8 58.4 50.8 16.5 6mm (3)

SLIM2 174.3 120.7 106.58-106.68 62.5 - 3.6 43.2 33.5 2.5 77.5 63.5 16.5 8mm (3)

N O P Q R S T U V W X Y**

25.9 107.2 121.4 152.4 76.20-76.35 114.3 14.0 14.0 40.6 120.6 10mm (2) _ (3)

34.5 139.7 165.1 203.2 106.68-106.83 174.3 16.5 16.5 50.8 157.5 12mm (2) 3/8 (3)

* See Table 3 for permissible Shaft Diameter. Bore Diameter is typically between Nominal Diameter+0.018 and +0.043 mm.

** Bolts supplied with bracket

Figure 2

Figure 1