User manual
Speaker connections:
Notes:
• Both the 4Ω, 8Ω, 70V and 100V terminals cannot be used at the same time.
• Impedances indicated in the gures represent the total speaker system (load) impedances.
Loads presented to the amplier must be equal to or greater than listed above. Speaker
impedances must be measured using a true impedance meter, do not standard multimeters.
WARNING!
Be sure to attach the supplied terminal cover attached after con-
nection. Because high voltage is applied to the speaker terminals,
car should be taken never touch these terminals to avoid
electric shock.
All speaker connections should be made using bare wire or suitable
insulated crimp terminals. Please ensure no loose strands are present
as these may short across terminals causing damage to the amplier
Total impedance
160Ω
Total impedance
160Ω
TOTAL LOAD OF SPEAKERS CONNECTED
ACROSS ALL ZONES PLUS SPEAKERS
CONNECTED TO THE MAIN OUTPUTS
MUST NOT EXCEED 240W (208.3Ω)
9