User manual

Identication:

1. Bass & Treble controls - Use to adjust the bass and treble response.

2. PROT LED - Protection indicator LED

3. Chime & siren LEDs

4. CLIP LED - This LED will ash when the output signal starts to distort

5. All call control - Press to page all zones

6. All call LED - When all call has been selected the LED will light up.

7. Zone selection LEDs - These LEDs will light up for which zone is selected

8. Zone selection buttons - Use these to select the zones

9. AC LED -This LED will light up when power is turned on and is used via the mains IEC socket

10. Power LED - This LED will light up once the amp is switched on

11. DC LED - This LED will light up when optional DC power supply is used

12. On/off power switch - Use the switch to power the unit on or off

13. Master volume control - Use this control to increase or decrease the master volume

15. Siren and chime selection buttons - Use these to select the siren and chime functions

16. Chime volume control - Use this control to increase or decrease the chime volume

17. Line & Mic volume controls - Use this control to increase or decrease the line and mic volume

18. Zone 1 - 5 Speaker outputs - Use this to connect the speakers to dedicated zones

19. Mains IEC power input socket - Use this to connect to the mains

20. Mic 1 priority selection button - When this button is selected, it will give priority to channel 1

over all other channels

21. Phantom 48V power switches - Use these switches to turn the Phantom +48V on and off for

each of the mic inputs

22. Optional DC power supply - Use this to connect to your optional DC 24V power supply

23. Combi XLR/6.35mm mono jack mic inputs sockets - Use these to connect the microphones

24. Line input sockets - Use these sockets to connect to your audio equipment

25. Line output socket - Use this socket to connect to your power amp or recording equipment

26. EMC input socket - Use this to connect to your emergency panel unit. When the EMC is

connected, the EMC has auto override over all other inputs

27. TEL input socket - Use this socket to connect to you telephone interface for paging and

announcements