Service manual

Disassembly
2 - 10 Removing the Hard Disk Drive in Bay One
2.Disassembly
Removing the Hard Disk Drive in Bay One
1. Turn the computer OFF, remove the battery (page 2 - 6) and turn it over.
2. Remove screws - in (Figure 2 - 3a), then lift the 3rd Modular Drive Bay cover off and set it aside.
3. Remove screw (Figure 2 - 5b), then gently push the device out of the bay (you may need to use a screwdriver to
do this).
4. Remove screws - (Figure 2 - 5c), and disconnect cable (Figure 2 - 5d), then take the HDD assembly out
of the case.
5. Remove screws - (Figure 2 - 5e) from the HDD assembly (note the disk orientation within the brackets).
Figure 2 - 5
Bay One HDD
Removal
Sequence
a. Remove the screws
from the Bay Three
cover.
b. Remove screw 5 and
push the device out of
the computer.
c. Remove the 4 screws
from the HDD case.
d. Disconnect the cable
and remove the HDD
assembly.
e. Remove the screws
from the assembly
brackets.

4. Drive Bay Cover
11. Drive Case
16. HDD
17. Assembly Brackets
•9 Screws
1 3 4
5
6 9
10
12 15
a.
b.
2
1
3
c.
5
d.
89
15
14
6
7
12
13
4
11
16
17
17
e.
10