Service manual

2 – 21
D ISASSEMBLY
2. DISASSEMBLY
Base Assembly Removal
BASE ASSEMBLY REMOVAL
Part A
Remove the Back Cover. (page 2-4)
Remove the I/O Bracket. (page 2-11)
Part B
Separate the Base Assembly from the rest of the system.
A. Disconnect the following 4 cables and 3 ground wires from the System Board.
4 Cables
(C1 & C2) The Power Supply to System Board (two cables from Connector CN2,upper, and Connector CN4, lower).
(Remove the clip which holds the above two cables together and put it aside.)
(C3) The HDD to System Board (from Connector CN30)
(C4) The USB Board to System Board (from Connector CN35)
3 Ground Wires
(W1) A ground wire with the USB Cable fixed to the System Board with a screw.
(W2) A ground wire fixed to the Right Speaker with a screw.
(W3) A ground wire fixed to the Left Speaker with a screw.
B. Remove 4 screws (A, B, C & D).