CLIFF CONTROL KNOBS Knobs for Rotary and Slider Potentiometers.
Instrument Control Knobs We produce a versatile range of knobs designed to enhance the appearance - functionality of any equipment to which they are fitted. Knobs are made to high standards of finish in order to satisfy the users most exacting requirements. All models are moulded in black Nylon, ABS or PP. Some models can be supplied in white or grey colours. Other custom made colours are produced subject to reasonable order quantity. (Sometimes setup charges are required).
K85 K85M, K85MS Available for push fitting only. 8 colours of cap are available. Caps push into the top of the knob, and can locate in any position. Skirt or cap or both may have a marker line. Supplied unassembled. Not available in rubber finish. Knobs packed 250 knobs / bag. Caps packed 100 or 1000 / bag. K85M - Available for push fit only. Two colour moulded. Body and line / cap can be 8 contrasting colours. Suitable for applications where quantities used demand very low cost.
K9, K10 K11, K12 Both have separate push in caps. (8 colours). Knob and cap can be plain or with a line. K9, K10 - Packed 250 / bag. Caps 100 or 1000 / bag. Both have separate push in caps. (8 colours). Knob and cap can be plain or with a line. Skirts used on K6 can be used on K12. K11, K12 - Packed 200 / bag. Caps packed 100 or 1000 / bag. K13 A,B,C,D,E,F,G 'ENGINEERING KNOBS' This range of knobs incorporate metal threads or threaded studs.
K17 C18 Initially designed for electronic cosmetic equipment. The knob has a fine serrated edge, a matt non reflective finish, and a prominent marker line. A low cost nylon knob, produced in all black version , or coloured cap version. Caps supplied pre-fitted, cannot be removed. Marker line has 4 possible locations. Available in push fix only. Cap colours - Black, White, Grey, Green, Blue, Yellow or Red C18 - Packed 500 or 1000 / bag. K17 - Packed 250 / bag.
SLIDER POTENTIOMETER CONTROL KNOBS CS - SERIES Nine different designs are produced. 3 types have option of 4mm. 6/8mm. shaft fitting. All knobs have matt non reflective finish to match our K9 - K12 series and C18. Standard colour - Black. CS-1 : L 23mm. W 11mm. H 11mm. CS-8 : L 17mm. W 10mm. H 8mm. CS1 CS1A CS1B CS8 Length 20mm. Width 14mm. Height 13mm. (for 6/8mm. shaft) (for 4mm. shaft) (for 4mm. shaft) (for 6/8mm. shaft) CS2 CS2A CS2B Length 29mm. Width 13mm. Height 7mm. (for 6/8mm.
CUSTOM MADE KNOBS AND BUTTONS Where standard designs do not suit customers requirements, we can produce to your own designs. Sometimes we are able to modify existing tooling to avoid the need to make new full moulds. Our two colour moulds are designed to be adaptable to produce custom designs (within certain size constraints), without the need to make a full mould, so custom designs can be achieved at moderate tooling cost - usually about 50% of the cost of a full mould.
ORDERING INFORMATION STANDARD COLOURS The colours shown below are for reference only and may not be identical to actual colours. If exact colour selection is required, we would be happy to provide samples for your evaluation. BLACK RED BLUE YELLOW GREEN BROWN ORANGE GREY WHITE In addition to the above, custom colours are available for single & multi colour moulded knobs. Call us to discuss your specific requirements.