Owner`s manual

System Components
The Concept 600 kit contains the following components:
Wiring Considerations
How to Sol der
1.Strip about one-half-inch of insulation from the wires and slip a piece of shrink tubing over one o f them.
2. Join the wires, then heat the wires with a soldering gun whilst touching solder to the wires until the
solder melts.
3.Pull the wires to test the solder joint, then position the loose shrink tube over the solder joint and gently
heat with a hot air gun so that it tightly seals and insulates.
How to Secure Non-locking Connectors
1.Join the two non-locking connectors together as indicated in the installation instructions for the component you are
installing.
2.Wrap the cable tie around the connector as shown and tighten it securely around the connectors.
Wiring Description for the 24-Pin Connector
Pin Col our Con nects to Inputs Outputs
1 Red/Black Prewired to the Proximity Sensor output 5V Max.
3 White/Blue Prewired Proximity Sensor input connector Analog
4 Violet Prewired to the LED connector Positive, 16mA Max.
5 Black/Grey Ignition coil or tach input Pulse
6 Red Prewired to the Tilt Sensor and siren connectors Positive, 3.5V Min.
8 Grey/Yellow Boot trigger switch Negative, 3.5V Min.
9 Black Prewired for the siren, sensors, LED and valet
switch
Ground
10 Black Ground Ground
11 White Prewired to the Valet Switch connector Negative-3.5V Min.
13 Grey/Violet Auxilliary A output Negative, 250mA Max.
14 Grey/Blue Auxilliary B output Negative, 250mA Max.
15 Grey/Red Auxilliary C output Negative, 250mA Max.
17 Yellow Optional airhorns Negative, 250mA Max.
18 Red Battery Positive, 7V Min., 18V Max.
20 Green Prewired to the Tilt Sensor connector Negative, 250mA Max.
23 White/Black Bonnet trigger switch Negative, 3.5V Min.
24 Orange Prewired to the Tilt Sensor connector Negative, 3.5V Min.
2 Con cept 600/299
One Prewired 24-pin Connector Harness
One Prewired 14-pin Connector Harness
One Concept 600 Control Unit with Stainless Steel Enclosure
One Electronically Programmable Proximity Sensor
One Digital Tilt/Motion Sensor
One Wireless FuelGuard
Two Remote Transmitters
One Superheterodyne Extended Range Receiver
One LED Status Indicator
One PlainView Coded Valet Switch 2
One Self-Powered SmartSiren 4
One Hardware Kit
One Owner’s Manual
One Wireless FuelGuard Location Form
One Certification of Installation Form
Two Window Decals
One Warranty Card
One Guarantee Card