Owner`s manual

Wiring Description for the 14-Pin Connector
Pin Col our Con nects to Inputs Outputs
1 Brown Indicator light output Max. 15A
2 Blue/White Brake output Max. 15A
3 Brown Indicator light output Max. 15A
6 White/Orange Door unlock common Max. 15A
7 White/Green Door lock common Max. 15A
8 Red/White Indicator and brake light input Positive, Vbatt Max. 15A
9 Brown/Red Interior light input (+ or -) Vbatt or Ground
10 Grey Door trigger input (+ or -) Negative, 3.5V;
Positive, 4V
11 Red/Orange Door unlock normally open Max. 15A
12 Red/Green Door lock normally open Max. 15A
13 Grey/Green Door lock normally closed Max. 15A
14 Grey/Orange Door unlock normally closed Max. 15A
Wiring Description for the 12-Pin Connector
Pin Label Con nects to In puts Outputs
1 Ground Ground Min. 12 mA; Max. 5A
2 Window switch 2 Window switch 2 Relay, Max. 20A
3 Window motor 1 +12V out Window motor 1 Max. 30A
4 Window switch 1 Window switch 1 Relay, Max. 20A
5 Constant +12V 30A Fuse panel (+) Positive, Vbatt
6 Starter input +12V Starter input Relay, Max. 30A
8 Ignition output +12V Ignition output Continuous 20A, Max Surge 30A
9 Window motor 2 +12V out Window motor 2 Max. 30A
10 Starter output +12V Starter output Continuous 20A, Max Surge 30A
11 Ignition input +12V Ignition input Relay, Max. 30A
The current draw of the entire vehicle security system (whilst armed) is 20mA. Power supply voltag e is 7V
minimum and 18V maximum.
Passenger Compartment Connections
Control Unit and Superheterodyne Extended Range Receiver
The Con cept 600 con trol unit must be in stalled in side the ve hi cle. Un der no cir cum stances should the unit be
in stalled un der the bon net or other simi larly hos tile en vi ron ment.
1.Select an area behind the dash to mount the control unit using the supplied wire tires, but do not permanently affix it until all
wiring and testing is complete. To maximize the sensitivity of the tilt/motion sensor, make sure t he control unit is mounted as flat
as possible behind the dash (i.e., not mounted on its side).
2. Plug the extended range receiver in to the control unit. Mount the extended range receiver away fr om the control unit and run
the antenna either up the window pillar and affix it to the windscreen, or under the dash, away fro m metal. The position and
location of the receiver will effect remote control range. Do not fold the excess cable or antenna wire. Do not make hard, sharp
bends.
Door Trigger/Interior Light Supply
Please refer to the Door Trigger/Interior Light Supply section in this binder for information on polarity testing and connections.
Central Door Locking System
Please refer to the Door Locks section in this binder for information on circuit types and connections.
4 Con cept 600/299