User Guide

Fault-Proof Driving Safety

AutoImmobilizer was intelligently designed to ensure that it can

never

immobilize your vehicle while the engine is running. Even in the unlikely

event of a malfunction or even if the system fuse blows, AutoImmobilizer

will never shut down the engine while you are driving.

How to Add New ComputerKeys

Your AutoImmobilizer comes with two ComputerKeys, and can recognize up

to four different ComputerKeys. Additional ComputerKeys can be purchased

from any Clifford Electronics dealer. To add one or more new

ComputerKey(s), use the following procedure:

1. Insert your car key and turn the ignition switch to the “ON” position.

2. Use a pen to press the recessed button on the underside of the

ComputerKey receptacle, then insert your original ComputerKey. The

LED will blink once.

3. Continue to hold in the button, then remove your ComputerKey. The

LED will turn on.

4. Release the button. The LED will stay on.

5. You now have 30 seconds to insert and remove the new ComputerKey(s).

You’ll notice that when you do, the LED will blink off for an instant to

confirm that the digital code of the new ComputerKey as been

memorized in the system’s non-volatile memory.

6. Turn the ignition off. The LED will turn off.

How to Delete the Code(s) of Lost or Stolen ComputerKey(s)

You can erase the code of a lost or stolen ComputerKey so that it can never

again disarm your AutoImmobilizer. Since the system can store four

different ComputerKey codes, simply repeat the above procedure four times

(if using two ComputerKeys, insert and remove each twice, if using three

ComputerKeys, program any two keys once and the other key twice).

AutoImmobilizer owner’s manual