Operation Manual

ManualsBrandsClimadiff ManualsAir ConditioningClima 18

INSTALLATION INSTRUCTIONS (optional)

Exhaust hose installation:

The exhaust hose and adaptor must be installed or removed

INSTALLATION INSTRUCTIONS

Water drainage:

Fig.16

Expansion plug

position

Adaptor

cap

Fig.17

Fig.18

accordance

with the usage mode.

COOL,

AUTO mode

Install

FAN,DEHUMIDIIFY mode

Remove

1. Install the window

Exhaust

adaptor B onto the exhaust

hose as shown in Fig.16. or Fig.17. Refer to the previous

pages for window kit installation.

2. Push the

Exhaust

hose into the

airoutlet opening

along the

the arrow

direction(See

Fig.18).

The exhaust hose can be installed into the wall

(Not

applicable

to the units without

adaptor

A, expansion

plugs and

wooden

screws of

Accessories

)

1. Prepare a hole in the wall. Install the wall Exhaust

adaptor

onto the

wall(outside)

by using 4

expansion

plugs and

wooden

screws, be sure to fix

thoroughly.

(See Fig.19)

to wall Exhaust

adaptor

Note:

Cover the hole using the adaptor cap when not in use.

The duct can be compressed or extended moderately

according to the installation requirement, but it is

desirable to keep the duct length to a minimum.

IMPORTANT:

DO NOT OVER BEND THE DUCT (SEE Fig.20)

CAUTION:

Fig.21

Continuous

drain hose

Remove the

drain plug

Fig.22

- During dehumidifying modes, remove the

drain

plug from the back of the unit, install the

drain

connector(5/8 universal female mender)

with

3 4 hose(locally purchased). For the

models

without drain connector, just attach the

drain

hose to the hole. Place the open end of

the

hose directly over the drain area in

your

basement floor. Please refer to Fig.21 &

22.

- When the water level of the bottom tray reaches

a predetermined level, the unit beeps 8 times,

the digital display area shows

. At this time

the air conditioning/dehumidification process will

immediately stop. However, the fan motor will

continue to operate(this is normal).

Carefully move the unit to a drain location,

remove the bottom drain plug and let the

water drain away (Fig.23). Re-install the bottom

drain plug and Restart the machine until the

symbol disappears. If the error repeats, call for

service.

NOTE: Be sure to reinstall the bottom drain plug

before using the unit.

max

120CM

min

30CM

Make sure that there is no

obstacle

around the air outlet of

the

exhaust

hose (in the range of

500mm)

in order to the

exhaust

system works properly.

Bottom drain plug

Fig.19

Fig.20

Fig.23

12 13