Specifications

Page 53 of 77
Initial Orientation and Warranty Guidelines
During your initial orientation, we will confirm that all painted or stained surfaces are in acceptable
condition. The “5 foot, 2 second” rule will apply. Briefly, the “5 foot, 2 second” rule states that a
paint deficiency will only be repaired if you can see same from a standing distance of 5 feet and
within a time frame of 2 seconds. If not, it is not a defect.
The Developer will touch up paint as indicated on the initial orientation list. You are responsible for
all subsequent touch-up, except painting we perform as part of another warranty repair. Please
note that paint touch ups made during a warranty visit may:
 Be visible under certain lighting conditions; and
 Not match the surrounding area. Over time, paint colours fade. Due to the effects of
time on paint, as well as possible dye lot variations, touch-ups are unlikely to match
surrounding painted areas).
Phone/Cable Outlets
Homeowner Use and Maintenance Guidelines
Your home is equipped with numerous outlets. Initiating service, adding additional outlets or
revising outlet locations for decorating purposes or convenience is the homeowner’s
responsibility.
Initial Orientation and Warranty Guidelines
The Developer will correct faulty outlets that are discovered during the initial orientation. For
example, if a kitchen phone outlet is positioned too close to a cabinet and prevents a wall phone
from being installed, the Developer will remedy same.
The Developer will also repair faulty wiring from the outlet service box into the home. The
warranty period for same is two years, and begins on the closing date when the unit is first sold.
From the service box outward, care of the wiring is the responsibility of the local telephone service
company.
Plumbing
Homeowner Use and Maintenance Guidelines
Your plumbing system has many parts, most of which require little maintenance. Proper cleaning,
occasional minor attention, and preventive care will assure many years of good service from this
system.
Aerators
Even though your plumbing lines have been flushed to remove dirt and foreign matter, small
amounts of minerals may enter the line. Aerators on the faucets strain much of this from your
water. Minerals caught in these aerators may cause the faucets to drip because washers wear
more rapidly when they come in contact with foreign matter. Please note that as part of normal
maintenance, you will need to occasionally clean your aerator.
Cleaning
Follow manufacturer's directions for cleaning fixtures. Avoid abrasive cleansers. They remove the
shiny finish and leave behind a porous surface that is difficult to keep clean. Clean plumbing
fixtures with a soft sponge and soapy water (a nonabrasive cleaner or a liquid detergent is usually
recommended by manufacturers). Then polish the fixtures with a dry cloth to prevent water spots.
Clogs
Many plumbing clogs are caused when foreign materials are inserted into plumbing lines.
Examples of foreign materials include disposable diapers, excessive amounts of toilet paper,