User manual

7
ATC32U02 Communicating, Programmable Thermostat - User Manual
Rev.: 24 Feb., 2014
MAIN MENU
SET DATE AND TIME
HOLD
SECURITY LOCKOUT
PROGRAM
FAN
MODE
SETTINGS
HOLD MENU
PERMANENT
PREVIOUS
SELECT OPTION
VACATION
Set the Vacation Hold heating/cooling setpoints.
The Vacation Hold Temperature Display Mode
shows either one (in Heat, Cool, or Emergency
Heat modes) or both (in Auto mode) temperature
setpoints. Adjust the setpoints using the up/down
arrow buttons. Navigate between setpoints using
the left/right arrow buttons. Press the center
button to save changes.
• Heat Setpoint (default current Heat Setpoint):
valid range: 55°F to Maximum Heating Setpoint
Limit (section 5.6.8)
• Cool Setpoint (default current Cool Setpoint):
valid range: Minimum Cooling Setpoint Limit
(section 5.6.8) to 95°F
5.1.1 AUTO DAYLIGHT SAVING
When enabled, the thermostat automatically adjusts
the time for daylight savings time.
5.1.2 SET DATE AND TIME
To set the current date and time, use the up/down
arrow buttons. Press the center button to save
changes.
5.1.3 DISPLAY DATE AND TIME
When enabled, the thermostat will display the date and
time (section 5.1.2) on the top line of the Main screen.
NOTE: When the thermostat is confi gured for non
programmable mode by installer the Display Date and
Time setting defaults to NO.
Section 5.2 and 5.3 will not be displayed if the
thermostat is set as “non-programmable” in installer
settings (contact your dealer to change).
5.2 HOLD (Temperature)
The thermostat can be programmed to hold the temperature
and override the program schedule for a set time. The
thermostat can accommodate any hold schedule, whether the
temperature hold is desired for a few hours or a few weeks.
69
°
RH 40%
10/13/11
8:27 AM
FAN AUTO
OFF
TEMP
FAN MODE
RH
MENU
MAIN MENU
SET DATE AND TIME
HOLD
SECURITY LOCKOUT
PROGRAM
FAN
MODE
SETTINGS
5.0 Main Menu
NOTE 1: The thermostat must be in any mode other than
OFF (section 2) to set a vacation/permanent hold.
NOTE 2: The thermostat must be confi gured for
programmable mode by installer) to access the
Hold modes.
5.2.1 VACATION (Hold)
This feature can suspend the program schedule by
using specifi ed heating/cooling setpoints for extended
periods of time.
5.2.1.1 HOLD TEMPERATURE