Instructions / Assembly

ManualsBrandsClimateRight ManualsHeater AccessoriesInterior Finishing Kit for CR2500ACH and CR5000ACH

IMPORTANT: READ OWNERS MANUAL & INSTALLATION GUIDE CAREFULLY

BEFORE ASSEMBLY AND USE

Read and follow all safety rules and instructions before operating this equipment.

THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY.

Please keep this manual for future reference.

INSTALLATION

INSTRUCTIONS

PORTABLE AIR CONDITIONER & HEATER ACH SERIES

CR2500ACH • CR5000ACH • CR10000ACH

CR10000ACH

CR2500ACH & CR5000ACH

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS PORTABLE AIR CONDITIONER & HEATER ACH SERIES CR10000ACH CR2500ACH & CR5000ACH CR2500ACH • CR5000ACH • CR10000ACH IMPORTANT: READ OWNERS MANUAL & INSTALLATION GUIDE CAREFULLY BEFORE ASSEMBLY AND USE Read and follow all safety rules and instructions before operating this equipment. THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. Please keep this manual for future reference.
PAGE 2
INSTALLATION INSTRUCTIONS REQUIRED TOOLS (NOT SUPPLIED) · Electric Drill · Pencil · Tape Measure · 3-1/2” Bi-Metal Hole Saw (See picture at right) · Six (6) - #6 Flat head wood or sheet metal screws, 1” length recommended. (Customer must choose the length and supply the screws based on the thickness and type material being screwed into.) · Screwdriver to match screw heads · Exterior caulk (optional) · Hacksaw (optional) Figure 1 Building Flange INCLUDED PARTS Quick Connect Hose System A.
PAGE 3
INSTRUCTIONS 1. Choose a firm, flat and level location next to the structure. Be aware of anything that may be sensitive to water as the unit will drain water from the condensation drain tube onto the ground. The unit must be within 4’ (48”) of the structure (closer, if there will be bends in the air hose) and 6’ to a 120V power outlet. The closer the unit is to the structure, the better the airflow will be. (See Figure 2.1) 2. Place the ClimateRight unit at the chosen location.
PAGE 4
6. With no obstructions behind the marked locations, drill out the holes with the 3-1/2” hole saw. 7. Once the holes have been drilled, insert a ClimateRight Building Flange (D). Note: Check the length of the flange, if the Building Flange is too long, it can be cut to length with a hacksaw. The grooves on the flange are spaced at 1” intervals. 8. If necessary, mark the screw hole locations with a pencil and drill pilot holes for the screws. (For #6 wood screws use a 1/16” drill bit.) 9.
PAGE 5
Questions or concerns? For assistance, please call Customer Service: 800-725-4628 777 Manor Park Dr. Columbus, Ohio 43228 www.climateright.