Instruction manual

SELECTING A LOCATION
7INSTRUCTION MANUAL
GLOSSARY OF TERMS
6 Climatouch
™
CT0-7TC-32H
CYCLE RATE - Cycle rate is the frequency that heating or cooling equipment is
turned on during a certain period of time. Cycle rate is often given in units of cycles
per hour (CPH).
DEHUMIDIFY - The process of removing moisture from the air.
DEHUMIDIFIER - Device used to remove moisture from the air.
DIFFERENTIAL - Differential is defined as the difference between the cut-in and
cut-out points as measured at the thermostat under specified operating
conditions. For example, if the thermostat turns the heating equipment on at 70
degrees F and turns the heating equipment off at 74 degrees F, then the differential
is 4 degrees F.
HUMIDIFIER - A device used to add moisture to a space.
HUMIDISTAT - A control which is operates the humidifier and is affected by changing
humidity.
HUMIDITY - Moisture in the air.
PROGRAMMABLE THERMOSTAT - A thermostat with the capability of automatically
adjusting temperature set point to pre-selected settings at pre-selected times.
SETBACK - The automatic alteration of the thermostat control point(s) by means
other than manually changing the temperature set point.
SET POINT - The desired temperature setting on an electromechanical or
electronic thermostat.
Install your Climatouch
™
thermostat approximately 5 feet (1.5 meters) above the
floor in an area with good air circulation.
Avoid the following locations:
:: Hot or cold air from ducts
:: Radiant heat for appliances or sun such as a skylight
:: Unheated or uncooled areas: for example an outside wall behind the thermostat.
:: Ensure that there is no furniture directly below or beside the thermostat.